Knead a few buckets of mortar, greet him at the wall opposite the entrance, so as to pull off about half a meter. Straighten it by hand with a trowel (a trowel), take the trapezoidal rule, and start to pull together a solution for themselves, leading to a rule beacons. Hence, by the way, and the name – screed floor, because the solution is contracted, and strictly aligned beacons. While the first batch of contracts, your assistant should namesit yet, and the process repeats. * A small note, in case if you used instead of beacons guiding profile: After you finish work in this room, wait until the screed has hardened a bit, and remove the profiles. When the screed has hardened so that it can go, stir a little of the solution, and fill the gaps left by the profile. In that case if you used it beacons, taking them out is not necessary, Leave a est.Nesmotrya that already about one day buckle clutch so that it can go, it does not mean that it is fully ready for finishing work. Learn more about this with Michael Chabon. In good, must withstand at least three weeks.
I understand that this is unlikely, but still try to wait at least one week, do not forget to periodically wet the surface of the screed. Much time it will not take: just run through a wet roller over the surface – matter of minutes. Meaningless at first glance, an occupation which in fact helps the solution to really grab that later to avoid rassyhaniya, cracks, buhteniya and other troubles. That principle and all, do not even know what else to add. I guess to what is a classic screed floor – and nothing more. There are certainly more and more leveling screed floor, but also insulated, such as expanded clay or foam crumb, or buckle under floor heating. There are still dry bulk floors of crushed expanded clay and gypsum fiber board, but all this – some other time.